Series U/APE

The U/APE series centrifugal fans are designed to take up air, even if dusty, at  temperatures of up to a maximum 80°C.
These fans are used in all the industrial systems requiring high pressures and low flow rates. Furthermore they can also be used for pneumatic conveyance.
The strong steel sheet spiral casings are rimmed and welded. These fans also have a base for the motor and the discharge angle can be regulated in 45° steps by rotating either clockwise RD or counter-clockwise LG (see discharge direction table).
The welded steel sheet impellers with forward-curved blades have been carefully balanced both statically and dynamically, and are connected directly to the motor shaft.
The motors installed are asynchronous, three-phase or single-phase, 2 poles, B3, with IP55 protection, self-ventilated, designed for continuous service and are UNEL and IEC compliant.

ACCESSORIES

	RP		inlet protection net
	GA		intaking vibration-damping joint
	RA		intaking joint
	RF		inlet flanged fitting
	CA		inlet counter-flange
	FL		inlet filter
	SA		inlet silencer
	SF		throttle valve
	RM		outlet protection net
	GM		feed vibration-damping joint
	CM		outlet counter-flange
	QT		outlet square-round joint
	SM		outlet silencer
	TS		discharge plug
	AV		vibration dampers

SPECIAL VERSIONS

	AI		made of stainless steel AISI 304 to extract corrosive fumes
	AS		anti-spark version in accordance with ANIMA-COAER standards (table NV105)
	HZ		manufactured to work at Hz. 60
	HT		conveyed fluid temperature up to a maximum of 250°C (this version is made with longer shaft motor and extra cooling fan)
	SB		arrangement 5 with motor type B5 or B3/B5 without motor support base
	TH		high protection for use in tropical climate with high degree of humidity
	TR		belt drive, 9 or 12 arrangement